Striker rod ball joints

This topic has 2 replies, 2 voices, and was last updated 5 years, 2 months ago by Norman Anderson.

Viewing 3 posts - 1 through 3 (of 3 total)

Author

Posts
13th September 2019 at 8:18 pm #25549
Norman Anderson
Participant
Hi folks, this is one of the ball joints on the end of the control rods (gearbox end).

10mm on one end, 6mm on the other, and the taper looks like 8mm, both right hand thread. It’s completely shot. Any idea where I can source two? It doesn’t look much like 515508/516038 from the parts diagram!

Many thanks!
14th September 2019 at 10:09 am #25550
Bernie
Participant
Noeman,

There are lots of ball joints available but I think the biggest problem you will face is likelty to be the taper. I shall check my “stock ” to see if I have any useable 2nd-hand bits.

In the meantime, you might like to see if these people can help (I have used them for other items such as side mirrors on stalks) ….

https://www.carbuilder.com/uk/throttle-linkage-parts#/pageSize=20&viewMode=grid&orderBy=0

If not, more generally …

https://www.google.com/search?sxsrf=ACYBGNQEso9qdqa-_541FAaeeXp3qslw0g:1568451488146&q=throttle+linkage+ball+joint&tbm=isch&source=univ&sxsrf=ACYBGNQEso9qdqa-_541FAaeeXp3qslw0g:1568451488146&sa=X&ved=2ahUKEwiNpbGO-c_kAhWtRxUIHcp4D2sQsAR6BAgFEAE&biw=1024&bih=715

B…………
14th September 2019 at 1:38 pm #25551
Norman Anderson
Participant
Thanks Bernie, I’ve searched Google, and will keep searching.

I’ve managed to unearth a couple of 516.038 Ball Pins in my stash (see below on the right). But the rod ends are completely shot. It is those that I’ll need (or a reasonable substitute).

Meantime, I’ll try Chris and see if John Gillard can help.
Author

Posts

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.