Air filter

Traction Owner’s Club › Forums › Technical › Engine › Air filter

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 17th July 2021 at 12:52 pm #28563
    Dave Thornley
    Participant

      Am in a bit of a quandary as to which air filter I need. I have the lozenze shape as shown in pics attached. Most seem to have a split in half version with top bolts or an end cap with clips. Mine has neither it has a single butterfly nut on the end cap. Only other one like it I have seen is on a youtube video.

      https://www.youtube.com/watch?v=KhQLQZLijVM&t=27s   at 26 seconds shows it plainly.

      I am not sure how I am supposed to fit a filter into mine as there are a couple of support brackets inside shown by the pics with red arrows. The distance from the end cap to where any filter could not go further is exactly 280mm which is the dimension of the one for supposedly the top bolt fitting, I think.2578

      28th July 2021 at 9:41 pm #28603
      Chris
      Participant

        Hi David, you have the same type of filter that I have. I changed the filter recently and don’t remember seeing any supports. The filter slides in. The filter element is 280mm long. From what you say the filter should slide in and then stop when it hits the support.

        Chris

        30th July 2021 at 9:57 am #28606
        Dave Thornley
        Participant

          That is what I thought. Have a 280mm filter on order from the club and intend removing the supports, not that they actually support anything. These seem quite a rare element holder as compared to the bolt and clip ones.

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.