Re: Re: Installing Piston Sleeves (&Pistons)

Loosely fit the cylinders without the gaskets and mark them 1-4. They should stand proud of the top of the block by .002″-(but check the manual to be sure, it’s been a while since I last did this.)To check the height, use a surface micrometer or a steel ruler and feeler gauges. A lathe will be needed to achieve the correct height. Then install the “figure 8” gaskets on the bottom where they sit in the block, install the sleeves and then install the head and torque it. Then do the rest. The gaskets will come with an engine rebuild gasket set. Not hard to do but you do need access to a machine shop. If you’re in France there’s still a lot of old-timers in garages who will probably be happy to help you.