Re: Re: Electric Power Steering on a Traction

[Anonymous]

Next was to double check all measurements and prepare to cut the original steering shaft……. gulp.

[attachment=2:3khar2do]P1060868.jpeg[/attachment:3khar2do]

The cut is made – does not really matter about being square etc as this end is shoved up the adapter never to be seen again. But I squared it off and cleaned it of course 😀

[attachment=1:3khar2do]P1060869.jpeg[/attachment:3khar2do]

The manual says to then place the adapter on the end and weld in place. I was not happy just welding around the base of the adapter, so I made three holes through the adapter, two of these I would fill with weld and the centre one I will place a pin through the steering shaft and adapter, belts and braces time.

[attachment=0:3khar2do]P1060870.jpeg[/attachment:3khar2do]