Buffer Installation

Traction Owner’s Club › Forums › Technical › Bodywork & interior › Buffer Installation

  • This topic has 3 replies, 2 voices, and was last updated 4 years ago by Bernie.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 13th November 2020 at 3:59 pm #27624
    Nigel Watling
    Participant

      Does anybody know of a knack to install the rubber cone shaped bungs in the top of the door openings on a light 15?

      Nigel

      13th November 2020 at 7:11 pm #27625
      Bernie
      Participant

        A little Fairy Liquid (other washing up products are available) and a lot of determination.  A plastic or wooden spatula can also help to ease it in.

        B……..

        13th November 2020 at 7:44 pm #27626
        Nigel Watling
        Participant

          Hi Bernie

          I have been doing as you suggested but perhaps need a better mind set in the first place, perhaps try again over the weekend, thanks for comments.

           

          Nigel

           

          13th November 2020 at 8:34 pm #27627
          Bernie
          Participant

            Assuming your grommets have a hole in the top, try poking them down into the hole with a small dowel or similar.  Make sure it has a rounded end to prevent breaking through the bottom of the grommet.

             

             

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.