Gearbox selector lever orientation.

Traction Owner’s Club › Forums › Technical › Gearbox & drive shafts › Gearbox selector lever orientation.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • 28th August 2019 at 11:13 am #25465
    Norman Anderson
    Participant

      Hello Traction experts.

      I’ve taken the selector assembly apart (it was badly corroded and siezed up). Given it a good cleanup and greasing – only to find the two long selector arms can be fitted either way up!

      !802XUD_Lo_Res62

       

      Any ideas?

      Thanks, Norman

      28th August 2019 at 11:23 am #25467
      Norman Anderson
      Participant

        I have this old image, but can’t be sure the levers were fitted correctly anyway!

        802XUD_Lo_Res20

        30th August 2019 at 9:31 am #25473
        Editor FP
        Participant

          Mine look like your old image, so are probably the right way up, ie: ball joints underneath.

          30th August 2019 at 11:39 am #25474
          Norman Anderson
          Participant

            Perfect, thanks Bryan

            9th September 2019 at 7:33 pm #25516
            Chris
            Participant

              I’m a bit late to the party but mine are like that too.

              unnamed

              Chris

              13th September 2019 at 8:13 pm #25548
              Norman Anderson
              Participant

                Thanks Chris, managed to fit the assembly whilst dropping a bolt into the clutch housing (that’s another story).

                The striker rod linkages are shot on the engine end. Will start a new thread looking for a supplier.

              • Author
                Posts
              Viewing 6 posts - 1 through 6 (of 6 total)
              • You must be logged in to reply to this topic.